Struct Pwr

pub struct Pwr { /* private fields */ }

PWR

Implementations

impl Pwr

pub const unsafe fn from_ptr(ptr: *mut ()) -> Self

pub const fn as_ptr(&self) -> *mut ()

pub const fn cr1(self) -> Reg<Cr1, RW>

PWR control register 1

pub const fn csr1(self) -> Reg<Csr1, R>

PWR control status register 1

pub const fn cr2(self) -> Reg<Cr2, RW>

This register is not reset by wakeup from Standby mode, RESET signal and VDD POR. It is only reset by VSW POR and VSWRST reset. This register shall not be accessed when VSWRST bit in RCC_BDCR register resets the VSW domain.After reset, PWR_CR2 register is write-protected. Prior to modifying its content, the DBP bit in PWR_CR1 register must be set to disable the write protection.

pub const fn cr3(self) -> Reg<Cr3, RW>

Reset only by POR only, not reset by wakeup from Standby mode and RESET pad. The lower byte of this register is written once after POR and shall be written before changing VOS level or ck_sys clock frequency. No limitation applies to the upper bytes.Programming data corresponding to an invalid combination of SDLEVEL, SDEXTHP, SDEN, LDOEN and BYPASS bits (see Table9) will be ignored: data will not be written, the written-once mechanism will lock the register and any further write access will be ignored. The default supply configuration will be kept and the ACTVOSRDY bit in PWR control status register 1 (PWR_CSR1) will go on indicating invalid voltage levels. The system shall be power cycled before writing a new value.

pub const fn cpucr(self) -> Reg<Cpucr, RW>

This register allows controlling CPU1 power.

pub const fn d3cr(self) -> Reg<D3cr, RW>

This register allows controlling D3 domain power.Following reset VOSRDY will be read 1 by software

pub const fn wkupcr(self) -> Reg<Wkupcr, RW>

reset only by system reset, not reset by wakeup from Standby mode5 wait states are required when writing this register (when clearing a WKUPF bit in PWR_WKUPFR, the AHB write access will complete after the WKUPF has been cleared).

pub const fn wkupfr(self) -> Reg<Wkupfr, RW>

reset only by system reset, not reset by wakeup from Standby mode

pub const fn wkupepr(self) -> Reg<Wkupepr, RW>

Reset only by system reset, not reset by wakeup from Standby mode

Trait Implementations

impl Clone for Pwr

fn clone(&self) -> Pwr

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl PartialEq for Pwr

fn eq(&self, other: &Pwr) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Pwr

impl Eq for Pwr

impl Send for Pwr

impl StructuralPartialEq for Pwr

impl Sync for Pwr